Damn & Blast !!!! again

[mickymidas]

Happened again !!!
Flywheel side bearing race working its way off crank & pushing through seal , leaving bearing on the p#$$. Any ideas of the cause & how to rectify the problem ?

HB stage 4 P200 kit , HB fettled crank , B8es plug , 4% oil .

[eden]

New crank with a less worn race seating.

[mickymidas]

Cheers pal , think I had already made my mind up a new crank was needed , but needed a nudge in that direction

[wack 63]

Depending on how worn the crank is where the bearing sits, you may get away with some bearing retainer.

[Ginch]

And if the crank is buggered anyway, you could try a fairly liquid high temp epoxy to glue it into position.

[fastfrog]

Got the very same issue on my tameni T5 crank. Race was easy to fit on the crank shaft. Usually it needs a certain amount of strength to shove it down. Crank and bearing were brand new and I tried another bearing just to see and it the very same prob. Shaft was a bit to narrow. I glued the whole thing with a big amount of Loctite 648 and it never happened again....

[oldbiker]

there are bearing grades of loctite, but i`d be tempted to go for a new crank and bearing