Unable to Centralize Front Wheel

[soulsurfer]

Here you go, would this solve it with a disc hub spindle

No half nut required.

[Bilko]

You have just been promoted to Colonel Legend.

Pm on the way.

[Bilko]

Balls!!!!

Just nipped out half naked to have a look and the one I have is the same! Aaaarrrrrggghhhhhhhh!

Now I'm f@@ked!


Your promotion still stands by the way

[corrado]

Just nipped out half naked to have a look and the one I have is the same! Aaaarrrrrggghhhhhhhh!

Are you sure? The Spaq one doesn't have the recessed groove around the cut out for the stub on the link. The recessed groove allows you to remove the nut on the spindle on the plate side and for the stub to seat in the recessed groove. Soulsurfer's is a scootRS one. You can't remove that thin nut unless you have the recessed groove in the plate. It pulls the hub over by a couple of mm.

[soulsurfer]

Post a pic bilko

[Bilko]

Your right.

I was only looking at the recess where the nut goes.

[carlos fandango]

i had the same problem ended up getting the hub machined down 5mm to get it central

[chisel]

post a photo of the righthand side of the wheel/caliper mount so as i can see which spindle you have,i should be able to let you know what to do then.Martin

[Bilko]

Soul Surfers sending me his thingmie, so hopefully that will sort it.

[Bilko]

post a photo of the righthand side of the wheel/caliper mount so as i can see which spindle you have,i should be able to let you know what to do then.Martin

Is this ok?