http://scooterotica.org/forum/viewtopic.php?f=7&t=5751
Hydrolic clutch
-
carlos fandango
- registered user
- Posts: 792
- Joined: Wed Jan 07, 2009 12:51 am
- Location: Stourbridge
- Contact:
When i was young my Mom said "if you haven't got anything nice to say, say nothing at all " ..................... and people wonder why I'm quiet around them !
-
carlos fandango
- registered user
- Posts: 792
- Joined: Wed Jan 07, 2009 12:51 am
- Location: Stourbridge
- Contact:
Fux wrote:How`s that been treating you carlos?
So far so good, its off the road at the moment ( not clutch related 
) Its in a rb200 and its a four plate clutch with strong springs. I wouldnt say it was a two finger operation and not as light as i had hoped 
but lighter than before When i was young my Mom said "if you haven't got anything nice to say, say nothing at all " ..................... and people wonder why I'm quiet around them !
-
carlos fandango
- registered user
- Posts: 792
- Joined: Wed Jan 07, 2009 12:51 am
- Location: Stourbridge
- Contact:
Its a magura hymec from Venhill about £70.00 a quality product. they do various ones the only problem with them is that the travel on them is only about 10mm so you need a way to adjust them to get it in the right position.Fux wrote:Well, mine is a 2 hand operation at the mo....
What make was it, looks like I could set one of those up pretty easily. I like the fact that its easier to take the engine out.
An easier solution is the hebo ones that come as a kit http://www.trialsbits.co.uk/index.php?cPath=79 (the universal ones in the photo, but look out of stock) this is part cable operated so the slave cylinder can be fitted anywhere
Russ
When i was young my Mom said "if you haven't got anything nice to say, say nothing at all " ..................... and people wonder why I'm quiet around them !