series 1
Is it me or is there a blue Lego brick with ? On it ?
Its in bits scooter club: www.facebook.com/groups/132415046859320
-
scooterslag
- registered user
- Posts: 411
- Joined: Wed Jan 07, 2009 12:23 pm
- Location: Sunny Barnstaple
- Contact:
Sounds sweet- what motor you running chap? 
The mack daddy on the left!
-
simon k
- registered user
- Posts: 101
- Joined: Wed Jan 14, 2009 7:07 pm
- Location: Hackney London
- Contact:
ha ha that may be my rear carrier/seat ricspeed!
engine is indian 200 barrel bored out to 69mm,2mm off the top,lth reed manifold,boost port,racetour piston with windows and skirt cut, exhaust & transfers lowered,widened & polished.58mm mec eur crank.matched & flowed casings,exhaust & inlet manifold.
30mm phbh & twin tailpipe 42mm clubman. re profiled head running without gasket.
top end work by jb.
engine is indian 200 barrel bored out to 69mm,2mm off the top,lth reed manifold,boost port,racetour piston with windows and skirt cut, exhaust & transfers lowered,widened & polished.58mm mec eur crank.matched & flowed casings,exhaust & inlet manifold.
30mm phbh & twin tailpipe 42mm clubman. re profiled head running without gasket.
top end work by jb.
Looks and sounds lush
cos i was veiwing on an i pod 
Its in bits scooter club: www.facebook.com/groups/132415046859320
-
lammysilver
- registered user
- Posts: 71
- Joined: Tue Nov 10, 2009 11:50 pm
- Contact:
haha, that woke half of the east end!... when me and Goz left after the 'launch' there were quite a few police around following a bit of gang warfare :ninja: on your doorstep... that exhaust has had a negative effect on your local community... Looked and sounded rapid though! Good work mate its almost ready for France!!!
-
Ian Hepworth
reminds me of when my mate Andy lived 2 doors away and he had a FS1E which had a pipe so noisy you could hear him about 2 minutes away.
The motor sounds great!!!