sx headstock
-
stuart rimmer
- registered user
- Posts: 10
- Joined: Tue Nov 24, 2009 2:00 am
- Contact:
can anyone tell me the diameter of the steel bar that is fitted in to both sides of the headstock for throttle and gearhousing to fit onto as my gear side has snapped and needs a peice welding thanks
-
rog60
- registered user
- Posts: 588
- Joined: Fri Feb 13, 2009 7:18 pm
- Main scooter: Indian GP200
- Location: SWINDON (Wilts)
- Contact:
Do you mean the steel tubing that projects from the ends of the handlebarsstuart rimmer wrote:can anyone tell me the diameter of the steel bar that is fitted in to both sides of the headstock for throttle and gearhousing to fit onto as my gear side has snapped and needs a peice welding thanks
NO IT'S NOT A F***IN* MOPED!!!!!!
-
stuart rimmer
- registered user
- Posts: 10
- Joined: Tue Nov 24, 2009 2:00 am
- Contact:
yes mate the steel that is fitted into headstock looks like handlebars when you take everything off the headstock
22mm
Its in bits scooter club: www.facebook.com/groups/132415046859320
-
stuart rimmer
- registered user
- Posts: 10
- Joined: Tue Nov 24, 2009 2:00 am
- Contact:
thanks mate , now where to get some 22mm tube from anyone
most enginering workshops would be happy to sell you some
Its in bits scooter club: www.facebook.com/groups/132415046859320
-
rog60
- registered user
- Posts: 588
- Joined: Fri Feb 13, 2009 7:18 pm
- Main scooter: Indian GP200
- Location: SWINDON (Wilts)
- Contact:
And splice a piece on the end to replace the damaged bit. Had that done on a S3 gear support that had rusted badly at the end.RICSPEED wrote:most enginering workshops would be happy to sell you some
NO IT'S NOT A F***IN* MOPED!!!!!!