Locking Wire For Exhaust Nuts

[GP Rider]

I've just converted my downpipe to use a JL exhaust stub.
I'm going to be using the extended exhaust nuts and locking wire.
Can anyone post a drawing or a photo showing the best way to tie the locking wire on.

Many thanks
Chris

[RICSPEED]

some thing like this

[jonashford]

Gear cable and trunnions

[GP Rider]

some thing like this

Hi Rich

Do you leave the ends open or twist together?

[GP Rider]

Gear cable and trunnions

Hi Jon

Can you eloborate?

Thnaks
Chris

[jonashford]

i use a bit of old gear cable with a trunion to secure it, reason is the wire snaps, or at least it did on mine

[GP Rider]

i use a bit of old gear cable with a trunion to secure it, reason is the wire snaps, or at least it did on mine

Cheers for confirming

[RICSPEED]

some thing like this

Hi Rich

Do you leave the ends open or twist together?

twist together .. i did pic a while ago as same question was asked

[rosscla]

Just so I'm clear you twist the two loose ends together?

[RManson]

I did a story on this a few years back...

http://www.customclassictrucks.com/tech ... ewall.html

Not scooter related, per se, but it more or less covers it. After all, nuts are nuts right? Hope that helps!