Needles & Jetting with a Ramair

[Bilko]

What's weaker?

Running an X2 and wondering what to go to next as I'm on the weakest clip and still running rich.

I have X7 X6 X3

[Bilko]

From Cam Lam's site.

Leanest - X12 - X7 - X13 - X2 - X25 - Richest

So where do X3 and X6 fit in above?

[Bilko]

I went from the X2 to X7 and if I speed up gently it's ok, but if I pull anything more than that, it splutters a bit.

Also using a AS266 on a 30mm Delly on a stage 5 Mugello 225 with JL3.

Going through this because I've added a Ramair filter to keep the girlfriends leg dry and petrol free. :/

Any help would be appreciated

[drunkmunkey6969]

Splutters in what way? Does it splutter when you roll the throttle on gently and feed it, or just when you whack it wide open?

What main are you running?

[Bilko]

Does it splutter when you roll the throttle on gently and feed it, or just when you whack it wide open?

In between. When I open it up gently it's not too bad, but anything past that with a bit of welly and it's splutters.

132 main jet, but I didn't think the throttle was up past three quarters.