Brass clutch plunger.
-
10 inch Terror
- registered user
- Posts: 1447
- Joined: Tue Jun 29, 2010 9:17 pm
- Xbox live gamer tag: No.
- Playstation gamer tag: PLEASE!
- Main scooter: Lambretta LI Imola 185
- Location: Farnborough Hampshire
- Contact:
Hi all, does anyone know roughly how far the brass plunger on GP sidecasing pushes in when the clutch is engaged? I need to do a few measurements before i install a clutch. Thanks in advance Pete.
7mm/8mm roughly though that is with case off mind
Its in bits scooter club: www.facebook.com/groups/132415046859320
-
10 inch Terror
- registered user
- Posts: 1447
- Joined: Tue Jun 29, 2010 9:17 pm
- Xbox live gamer tag: No.
- Playstation gamer tag: PLEASE!
- Main scooter: Lambretta LI Imola 185
- Location: Farnborough Hampshire
- Contact:
Ok thanks. I'm about to fit a clutch and i'm a bit worried it will go coilbound, as there doesn't appear to be much space in there. I've fitted an AF clutch before and the springs seem almost fully compressed and it was fine, so i'm sure it will be ok.RICSPEED wrote:7mm/8mm roughly though that is with case off mind