Fitting a reed valve to rapido

[harpo]

hi im fitting a reed valve to my rapido 225 where do i put and how long for boost port thanks

[coaster]

hi im fitting a reed valve to my rapido 225 where do i put and how long for boost port thanks

It needs to run up from the inlet port and finish level with the top of the transfers somewhere around 22 - 25 mm wide but check where the ring pegs are. The depth will depend on the amoununt of metal you have to play with. When I cut mine into an SR 225 type barrel i managed to break through to the outside between the fins

I'm sure one of the professional will be on soon but in the meatime, try the search facility, this has been covered in some depth with pictures before.

[wack 63]

Have a look thru these http://www.lambretta-images.com/archive ... play_media

[coaster]

Have a look thru these http://www.lambretta-images.com/archive ... play_media

It says that album doesn'y exist

[wack 63]

Just worked for me?

[coaster]

Just worked for me?

Tried it again, still getting....... Error The selected album/file does not exist!

[harpo]

Thanks for the info lads think i'll buy a ts1 piston don't know about cutting the rapido piston might weakin it to much