Does anyone recommend a good cyl gasket sealant?
I have a skimmed and lapped head, I've used a small smear of Hylomar universal blue in the past but have run out.
Is there a decent alternative?
Clinder head gasket sealent
i use normal clear silicone
We sleep soundly in our beds because rough men stand ready in the night to visit violence on those who would do us harm
-
Ihateyoubutler
- registered user
- Posts: 244
- Joined: Thu Jan 08, 2009 4:13 pm
- Location: North west
- Contact:
Thanks Shocky, I was about to ask the same question.
so do british bike builders to stop them leaking, b and qshocky wrote:i use normal clear silicone
Yambond or Hondabond. Available on ebay branded as threebond from memory.
An impossible task on most british bikescezeta wrote:so do british bike builders to stop them leaking, b and qshocky wrote:i use normal clear silicone
Stag Wellseal is good. 
Ive used locktite for the last twenty plus years, before that I used to use gaskets that had a habbit of going pop if the Scooter was ridden too hard....Started using it after I ran a Yamaha DT175 piston with high comp head, the Locktite was reccommended by Dave Webster.....who was I to argue.... 
