Back Brake Pedal

[jason frost]

Heres how i fit them
first drill into the peg

then drill a 2/3mm hole at 90 deg to join up with the other hole

tap to M6

now heres the parts 2x front hub location washer 1x 12mm shim ( the one that goes over the clutch arm o-ring ) 1x M6 repair washer 1x grease nipple

hub washer first

pedal then the other hub washer

shim washer, you may need 2 to take up the play

and last the repair washer and grease nipple

And heres how to sort out a worn peg
first cut it off

drill and tap to M8

then use a back brake pivot bolt

the replace the peg

[bristolmod]

Clever................like the rear brake pivot bolt idea.

i'm never too old or senile to learn about Lambrettas

thanks

Chris

[TS1-200]

I like it, brilliant.

[byron]

another good guide.
yes, use of the rear brake bolt is a good one
thanks for sharing

[J1MS]

.....Brilliantly simple.....

[red ghost]

I can sense a book comming along...

[rog60]

Flippin' brilliant. Some time ago I wondered how that could be done without welding a replacement on.
Got any similar ideas for replacing the battery tray without welding

[LI150]

Top ideas keep em coming........... :bouncyeng:

[andylaw7]

very good /innovative /splendid idea /super /smashing / great

[sean brady scooters]

excellent tip there Jason..................and good pics.......
have done that myself many times..............and works very well..........saves welding a new pin in etc.............