narrow toolbox fabrication

[lifes a drag]

does anyone know any good fabricators,

my mate wants a toolbox making to fit his legshield on his new cutdown,

i told him id ask on here as i think its probably the best place to find someone who has done them
for someone else before,

thanks

[Andy Pickering]

your location would help tbh..there is a toolbox that I've seen on a few cutdowns but not sure which ? Ld maybe, i will post a piccy when i get on the puter and off the phone.

[Craig H]

CS Engineering 01603 414666 Norwich

[RICSPEED]

most simply remove a section from the middle of a px one and weld together or as andy says an ld one ,check pics of cobbys scoot in show your cutdowns thread

[Andy Pickering]

As promised a pic of toolbox on cutdown..do believe this is off an Ld but not certain, maybe one of the Ld gurus could confirm..:



If it is you might get a remade one or be lucky and get a second hand one cheaper than having one fabbed up..

[lifes a drag]

cheers for the reply,s chaps

were in west yorkshire but buying one from anyware would be ok if someone recomends them.

The one on the picture looks just the joby so il tell him when i see him tonight.

Any other sugestions would still be appreitiated.

[sean brady scooters]

it http://www.youtube.com/watch?v=tJnj94WFxM4is an ld one,same as was used in this vid .

[jason frost]

I can do it or Gary Simpson hes in West Yorkshire me South Yorkshire both very good

[lifes a drag]

I can do it or Gary Simpson hes in West Yorkshire me South Yorkshire both very good

cheers Jason, i forgot about Gary Simpson and one of my mates is a good friend of his.

To be honnest this is the last bit of advice im giving him as im fed up of telling him to do anything and then he goes and does something that another person tells him ,,, normally someone who he hardly even knows

i told him tonight to put a PM exhaust on that he has instead of the nasty one from Nam that the scooter came with, he just seid someone told him to leave it as it was , ha ha

his last scooter would never pull 4th gear, i told him to fit a LI 150 gearbox,,, did he do it ,,, no ,, he just seid someone told him to fit a smaller front sprocket ,, i also told him to fit an Augusto 6000, telling him its part of the ignition ,, he seid his key didnt work properly ,, ha ha but he still didnt fit one

anyway thanx again for all your help and ill pass all the info over to him one last time ,,,,,,,,

[RICSPEED]

id get a bit more commitment off him before asking anyone then