SERIES ONE FRAME BREATHER(scooterotica forum bitza )

[RICSPEED]

OK with bits sourced off various members(off here and other forums) i now have the most important bit .......the frame

1958* 125 frame breather



i don't expect things to move to quick unless i lash it up in satin black for a while as i have a house to renovate first then build a garage before i can even think about a build..... not to mention a GP to finally finish




(*to be confirmed,need cert)*edit

*came back as 1959 weirdly

[RICSPEED]

ps i will be on the look out for bits ....but major purchases will have to wait as my c/c has took a hit

edit ........if anyone has a scrap s2 horncast that i can cut bits of to repair the s1 cast(bottom mounts)

[RICSPEED]

forks from el markio





led rear light ....



bit of a lash up but ill see how it goes

[MADSPEEDRB260]

Im just doing a Madspeed series 1 looks good mate.

[Robi D]

How did you do your LED taillight? looks good so far BTW.

[RICSPEED]

How did you do your LED taillight? looks good so far BTW.

it was this type -



sure you can get them cheaper ,motrax i think but i had it given a few years ago and was just sitting in a drawer so i just removed the led/circuit board and mounted on brass computer motherboard standoffs ..ill try rig up a 12v supply and try it

[RICSPEED]

how about two of these ?



only thing this would not light the reg plate very well
or this?

[RICSPEED]

STA48209 by ricspeed71, on Flickr

showing reg plate lights on under side

[RICSPEED]

tail

stop

[mark]

Looking good mate