Page 1 of 1

series 1

Posted: Fri Apr 16, 2010 4:10 pm
by simon k

Re: series 1

Posted: Fri Apr 16, 2010 5:25 pm
by RICSPEED
Is it me or is there a blue Lego brick with ? On it ?

Re: series 1

Posted: Fri Apr 16, 2010 5:31 pm
by scooterslag
Sounds sweet- what motor you running chap? 8-)

Re: series 1

Posted: Fri Apr 16, 2010 5:50 pm
by simon k
ha ha that may be my rear carrier/seat ricspeed!
engine is indian 200 barrel bored out to 69mm,2mm off the top,lth reed manifold,boost port,racetour piston with windows and skirt cut, exhaust & transfers lowered,widened & polished.58mm mec eur crank.matched & flowed casings,exhaust & inlet manifold.
30mm phbh & twin tailpipe 42mm clubman. re profiled head running without gasket.
top end work by jb.

Re: series 1

Posted: Fri Apr 16, 2010 5:54 pm
by Diablo
Looks and sounds lush

Re: series 1

Posted: Fri Apr 16, 2010 5:59 pm
by simon k
cheers Al. did you see the Nuneaton pit crew? ha ;)

Re: series 1

Posted: Fri Apr 16, 2010 6:04 pm
by RICSPEED
cos i was veiwing on an i pod :oops:

Re: series 1

Posted: Fri Apr 16, 2010 9:35 pm
by lammysilver
haha, that woke half of the east end!... when me and Goz left after the 'launch' there were quite a few police around following a bit of gang warfare :ninja: on your doorstep... that exhaust has had a negative effect on your local community... Looked and sounded rapid though! Good work mate its almost ready for France!!!

Re: series 1

Posted: Fri Apr 16, 2010 11:10 pm
by Ian Hepworth
reminds me of when my mate Andy lived 2 doors away and he had a FS1E which had a pipe so noisy you could hear him about 2 minutes away.

Re: series 1

Posted: Sat Apr 17, 2010 11:01 pm
by Manos
The motor sounds great!!!