Some of you may remember on the old forum I had some electrical problems with one of my scoots. Basically all lights including brake are not working.
I have replaced the stator for a 120 WATT BGM and swapped the Regulator and ignition switch for known good ones.
All wiring and earths checked and double checked.
I am getting around 15 volts at the brown in the headset, but if a connect a lamp across it, it does not illuminate. However, if I put the lamp across the yellow from the stator it does light up.
So the brown seems to be breaking down under load.
Any Ideas?
Further woes (electric)
-
- Dealer
- Posts: 957
- Joined: Sun Jan 11, 2009 12:49 am
- Main scooter: GP
- Location: Ipswich
- Contact:
Run another wire in place of the brown. Even if it is external and a temporary measure, it should prove whether the original brown is breaking down under load.
Mind you, 15volts seems a lot. i would expect it to be regulated to 12volts max, but if you do get it working at 15 volts, I reckon the lights will be bright
Martin
Mind you, 15volts seems a lot. i would expect it to be regulated to 12volts max, but if you do get it working at 15 volts, I reckon the lights will be bright

Martin
Martin