jetting idea

[col@garageartwerks]

just built a rapido 250 with mikuni tmx35 carb and taffy pipe on
just wondered if someone can give me an idea on jetting for this set up
cheers

[Diablo]

I think I remember Mark who posts on here saying his runs as low as a 250mj so I would maybe start with a 300 and work down. Needle wise a lot of RB22 Ts1 225 and 240 run well with a 58 needle so buy maybe that and a 57.
Allens performance in Nottingham for all your mikuni stuff.

[mark]

will check tomorrow if its dry

[col@garageartwerks]

thanks all