Scooterotica

I created a scan containing eight pictures of the gasket for the shifter mechanism. The original I used was from a P200e gasket set, but I thing the same gasket fits most if not all manual shift Vespas.



This may not print correctly for you. My file is a PDF which prints correctly on 8-1/2" x 11" paper and likely could be printed correctly on a larger sheet.

If you need a copy of the PDF, PM your email address to me.


Sent from my iPhone using Tapatalk

FWIW, the original gasket measured 0.024 inches thick while the copy I printed on kinda heavy paper measured 0.008

I presume the paper I printed on will serve adequately...

Edited attempting to correctly state the measured thicknesses. See next post.

Sent from my iPhone using Tapatalk

What can I say? Math is hard - especially when it involves nasty old decimal points. Photos of the actual micrometer measurements - ten times what I erroneously stated above.








Sent from my iPhone using Tapatalk

Gasket is 1-11/16 inch tall and 3-5/16 inch wide at its largest.


Sent from my iPhone using Tapatalk