Panel locks.

[10 inch Terror]

Hi all,
After recently losing a panel I'll going to fit some panel locks. The locks are the small type that you get on data cabinets etc. Has anyone got the dimensions and measurements of where best to fit them please? Thanks in advance Pete.

[gaz_powell]

Fit them in line with the rear frame grille

[gaz_powell]

Fit them in line with the rear frame grille

[Timbo]

I have an SX with standard Spring clip (not rollers) and I simply put a very small jubilee clip on the end once the panel is on. Does the job and should stop the chancers/scum bags. I've not done anything about my GP clip on panels but thought a very small screw at the very bottom of the rear of the panel. Anyone got any ideas?

[HxPaul]

Hi all,
After recently losing a panel I'll going to fit some panel locks. The locks are the small type that you get on data cabinets etc. Has anyone got the dimensions and measurements of where best to fit them please? Thanks in advance Pete.

http://www.ilambretta.co.uk/forum/viewt ... rity#p4660

[10 inch Terror]

Thanks chaps.

[gaz_powell]

im sure you already know but if not you need 20mm deep - pair keyed alike

[10 inch Terror]

im sure you already know but if not you need 20mm deep - pair keyed alike

Yes mate. I've already fitted them. Thanks anyway.

[10 inch Terror]

Just thought I'd add that the panel wasn't stolen, if came loose and fell off.

[fluff34567]

im sure you already know but if not you need 20mm deep - pair keyed alike

Yes mate. I've already fitted them. Thanks anyway.

Photo if possible?