Scooterotica

Evening all.

I'm pulling my hair out,

Trying to remove oil seal and can't budge the thing.

Got impact driver and broken a few pieces now. Had heat on it.

Started drilling pop out of seal

What's next


https://www.flickr.com/photos/151493805 ... ed-public/


Sent from my iPad using Tapatalk

You need to remove the for screws and the oil seal plate first......?

Hello drunk photo attached, on Flickr

That's what I'm trying to get off. Bloody thing won't budge.


Sent from my iPad using Tapatalk

if you cant budge the 4 screws /bolts with a screwdriver or impact, get a long dot punch and tap the corner of the slot anti clockwise carefully or even a thin bar grind to fine point , this will loosen the screws then they will just come out .

Try this.

http://www.ilambretta.co.uk/forum/viewt ... 7&start=20

fairspares wrote:if you cant budge the 4 screws /bolts with a screwdriver or impact, get a long dot punch and tap the corner of the slot anti clockwise carefully or even a thin bar grind to fine point , this will loosen the screws then they will just come out .

Will have a try. Fingers crossed.

hendy wrote:Try this.

http://www.ilambretta.co.uk/forum/viewt ... 7&start=20

Cheers hendy


Sent from my iPad using Tapatalk

Good bladed screwdriver. If it has a flat near the handle, even better. Grip this with adjustables or mole grips and keep strIking the handle end of the driver firmly whilst trying to turn screwdriver with grips.

Always managed to get them out with a decent impact driver myself . well once i had the impact driver set to the correct rotation