Scooterotica

Posted: **Sun Jul 10, 2016 2:25 pm**

Hi all, I'm fitting a BGM rear brake outer and it seems too long. Please see attached pictures.

My question is will it be ok this long or should I shorten it slightly and replace the end ferrule? Thanks in advance Pete.

Posted: **Sun Jul 10, 2016 2:58 pm**

My opinion is "leave it well alone" it will be fine.

Posted: **Sun Jul 10, 2016 3:01 pm**

Looks right to me

Posted: **Sun Jul 10, 2016 3:02 pm**

I cut about half inch off my outer it wasnt a bgm cable though. Think you need bit of extra length on outer for engine movement.

Posted: **Sun Jul 10, 2016 3:14 pm**

Cheers fellas, I'll leave it as is then.

Posted: **Sun Jul 10, 2016 3:56 pm**

mine was same 10 inch i tywrapped it to frame out the way of plug

Posted: **Sun Jul 10, 2016 4:12 pm**

Mine is the same length,I route my outer to the inside of the plug.

Posted: **Sun Jul 10, 2016 5:42 pm**

When you fit the cable plate behind the choke lever it will probably be the right length and keep it away from the plug.

Outer rear brake cable.