Scooterotica

does anyone know the thread size/pitch for the left hand thread on front/ rear hubs
changing to sip tubeless rims and forgot thet need the longer studs in.......freshly painted hubs and having a nightmare removing originals
2 out ok and two solid .am having to drill out and need to buy taps to suit
taaaaaaaa
phil

10x1 LH is the common one but there are some 11x1 LH examples out there (not sure which manufacturers they are )

ta gaz its the original 63 li125 hub and is a 10mm
so its a std pitch not the fine then?
ta
phil

Std metric coarse pitch for M10 should be 1.5mm. the hub studs are left hand M10 x 1.

You can get the tap from eBay, Chinese ones are cheap enough and adequate for the job of cleaning up threads. They take abou a week to arrive.