Scooterotica

Hi peeps,

I think ive sorted a cheap LML125 engine for my cutdown rat scooter.Its only just been ran in by a fellow club mate so i know its a good runner,but i remember how slow my px125 was years ago im thinking of a top end kit.As i dont wanna spend too much (whole point of this cutdown project) i was thinking either the good olde DR177 kit,or the 5 port 150 kit.Might possibly go up on the clutch tooth too.What do you guys think?

If you don't want to pay for a pinasco 177, then go for the dr177.


Sent from my iPad using Tapatalk

If you want to kit an LML motor, you might want to replace the crank as well, I've seen several of these fail with just a DR177 kit and a pipe.