Handlebar Diameter

[Boreham]

Could anyone advise the ID of the GP clutch and throttle bar ends, i wanted to order some bar end weights/extensions but the headset is at the sprayshop
Cheers

[corrado]

1 inch. Motorbike bars are generally 22mm so most bike bar ends don't fit well.

[warts]

I think quite a few Harleys and metric cruisers use 1" bars.
Off road/ADV bikes with alloy bars too?

[shocky]

I welded small discs on my bars drilled and tapped to 6mm and used some cheap aluminium bar ends cost under 3 quid from china , they had rubber bungs onthe end that when you tighten up expand inside hollow motorcycle bars I didnt use those bits ill try and upload some pics

[shocky]

Sent from my C5303 using Tapatalk

[shocky]

Sent from my C5303 using Tapatalk

[Boreham]

Cheers Shocky, a good alternative and theres loads of option options available

[Donnie]

You are aware that you'll have to cut the throttle and gear rods, shorten them and do some fabrication if you want to fit the internal fitting ones?