Hi.
RB20 + this manifold and PHBH30 fits under sidepanel in a jet200?
Thanks!
RB20 + LTH/Jimmers manifold
-
coaster
- registered user
- Posts: 3125
- Joined: Wed Jan 07, 2009 12:35 pm
- Location: London and Norfolk
- Contact:
I cannot be certain with an RB but I'm using an LTH short manifold on a TS1 and it fits under an LiS slimstyle panel with a GP or Breathsweet elbow and remote filter BUT I am using a BGM PWK 30mm carb which is about 20mm shorter than a PHBH. The Mikuni is another short option.ArKaTxU wrote:Hi.
RB20 + this manifold and PHBH30 fits under sidepanel in a jet200?
Thanks!
-
jonashford
- registered user
- Posts: 445
- Joined: Wed Oct 20, 2010 4:47 pm
- Main scooter: Lambretta SX RB235
- Location: GRIMSBY
- Contact:
i use a rb lth manifold with a tmx 35 on sx panels there is loads of room, but there was plenty with the std manifold as well
-
ArKaTxU
- Dealer
- Posts: 340
- Joined: Wed Jan 07, 2009 8:26 am
- Main scooter: TV175 64-Jet200 68-Jet200 82
- Location: Rias Baixas
- Contact:
In ScooterCenter catalog they say that BGM PWK 28/30 have 85mm and PHBH 90mm. Its correct? Because if BGM PWK 28 have 70mm I think that is a good option too.coaster wrote:I cannot be certain with an RB but I'm using an LTH short manifold on a TS1 and it fits under an LiS slimstyle panel with a GP or Breathsweet elbow and remote filter BUT I am using a BGM PWK 30mm carb which is about 20mm shorter than a PHBH. The Mikuni is another short option.ArKaTxU wrote:Hi.
RB20 + this manifold and PHBH30 fits under sidepanel in a jet200?
Thanks!
Yes, I have used TMX35 but I want something smaller this time.jonashford wrote:i use a rb lth manifold with a tmx 35 on sx panels there is loads of room, but there was plenty with the std manifold as well
Thanks!
-
coaster
- registered user
- Posts: 3125
- Joined: Wed Jan 07, 2009 12:35 pm
- Location: London and Norfolk
- Contact:
I'll measure a PWK and a PHBH for you when I get up to Norfolk in an hour or so just to make sureArKaTxU wrote:[.....In ScooterCenter catalog they say that BGM PWK 28/30 have 85mm and PHBH 90mm. Its correct? Because if BGM PWK 28 have 70mm I think that is a good option too.
-
coaster
- registered user
- Posts: 3125
- Joined: Wed Jan 07, 2009 12:35 pm
- Location: London and Norfolk
- Contact:
PWK measures 83mmcoaster wrote:I'll measure a PWK and a PHBH for you when I get up to Norfolk in an hour or so just to make sureArKaTxU wrote:[.....In ScooterCenter catalog they say that BGM PWK 28/30 have 85mm and PHBH 90mm. Its correct? Because if BGM PWK 28 have 70mm I think that is a good option too.
PHBH bare measures 90mm
PHBH with plastic bell mouth measures 97mm
I was a bit out with my previous guesstimate
