Page 1 of 1
sandblasting problem
Posted: Fri Jun 06, 2014 10:24 pm
by mickey
ok so i just sandblasted my legshields using crushed glass and now i have a metallic looking finish, caused probably by too high a pressure. can i get away with priming over this or do i need to sand it all off.
Re: sandblasting problem
Posted: Wed Jun 11, 2014 9:29 am
by mickey
ANYONE?
Re: sandblasting problem
Posted: Wed Jun 11, 2014 9:56 am
by Stampede
No, that´s the rule with crushed glass, you´ll get a very smooth surface compared to the "real" sandblasting.
Re: sandblasting problem
Posted: Wed Jun 11, 2014 5:13 pm
by coaster
You get residue embedded in the surface with grit blasting too, it will sand off very easily either by hand or with a flap wheel. Something like 80 grit should do it.
Re: sandblasting problem
Posted: Wed Jun 11, 2014 6:42 pm
by mickey
k thanks a quick rub down it is then
