Any one give me a head start with jetting , just getting everything back together and could do with a guide.
Cheers guys.
RT195 26mm Delly + Clubman jetting
-
Mike - - Bristol
- registered user
- Posts: 64
- Joined: Sun May 02, 2010 2:46 pm
- Main scooter: Silver Special 195
- Location: Unsurprisingly Bristol
- Contact:
-
Special X
- registered user
- Posts: 407
- Joined: Wed Jan 07, 2009 9:38 am
- Main scooter: Lambretta 125 special 230cc
- Location: Wakefield
- Contact:
52 pilot X13 2nd clip (may need 1st clip if over rich AV266 110 main Will be a little rich all the way. After a few plug chops you might need to go to AV264 with the needle on 2nd/3rd clip. You'll need a bigger main if you put an expansion on it.
-
jason frost
- Dealer
- Posts: 485
- Joined: Wed Jan 07, 2009 11:45 am
- Contact:
Which clubman? inlet manifold ? and have you changed the needle valve ?
-
Mike - - Bristol
- registered user
- Posts: 64
- Joined: Sun May 02, 2010 2:46 pm
- Main scooter: Silver Special 195
- Location: Unsurprisingly Bristol
- Contact:
Thanks guys.
Jason it's a 42mm Clubman , matched 200 inlet. Not changed anything just gathering info at the moment.
My plan is to get it close until it's run in and then maybe go 30mm and I have a PM expansion pipe.
Jason it's a 42mm Clubman , matched 200 inlet. Not changed anything just gathering info at the moment.
My plan is to get it close until it's run in and then maybe go 30mm and I have a PM expansion pipe.