Anyway I presume the 50 would be a bit leaner. Need a new one so was wondering wether to try the 50
Ta
Sef
RB20 40 - 50 slide?
-
sydduckett
- registered user
- Posts: 1900
- Joined: Wed Jan 14, 2009 12:21 am
- Contact:
Is anyone running a 50 slide in there RB20, this is presuming your using a dell vhsh 30. I run a 40 and noticed that AF,s site says 50 but when you call them they then say 40...
Anyway I presume the 50 would be a bit leaner. Need a new one so was wondering wether to try the 50
Ta
Sef
Anyway I presume the 50 would be a bit leaner. Need a new one so was wondering wether to try the 50
Ta
Sef
-
sydduckett
- registered user
- Posts: 1900
- Joined: Wed Jan 14, 2009 12:21 am
- Contact:
Toddy wrote:What's it running like with a 40 ? Mine ran a 40 in the same carb and dynod with it in as well
At the moment like a bag of bolts, hence new slide and slide housing. But prior to that went well, always had good plug colour so wondered if knocking it up to a 50 might give me a bit more without being to lean. I have found a 45 on a couple of karting sites so was going to go for that but chickened out and brought the 40........again....
-
bazman
- registered user
- Posts: 578
- Joined: Wed Jan 07, 2009 9:02 am
- Playstation gamer tag: bazman70
- Location: Annan S.W. Scotland
- Contact:
Atomiser and needle ok as they wear very quickly, don't be tempted to go to a 50 slide as this can lean it right off when you shut down from high revs and nip up!!
I should know...
I should know...
-
sydduckett
- registered user
- Posts: 1900
- Joined: Wed Jan 14, 2009 12:21 am
- Contact:
bazman wrote:Atomiser and needle ok as they wear very quickly, don't be tempted to go to a 50 slide as this can lean it right off when you shut down from high revs and nip up!!
I should know...
Got in, slide arrived. Next door signed for it. They are now not in....
Was hoping to get out tonight......hoh hum
Re the atomiser i think ill probably replace that as well. Needle seems a bit loose as well so that will also have to go.