Quick one, can the flywheel side oil seal be done in situ or do u have to split the cases. Its a P2 motor.
Cheers]
:fb:
PX Flywheel side oil seal
-
gaz_powell
- registered user
- Posts: 1208
- Joined: Sat Mar 28, 2009 1:10 pm
- Location: hartlepool
- Contact:
yes
no problem at all - use a small pick to remove the existing - lightly grease up the new seal and pop it on carefully and square - it should go on with finger pressure only - if it is tight make a soft drift
best of luck
no problem at all - use a small pick to remove the existing - lightly grease up the new seal and pop it on carefully and square - it should go on with finger pressure only - if it is tight make a soft drift
best of luck
