Franspeed stub question..

[sydduckett]

Got this stub for a Franspeed for my rb, its not a good fit and theres quite a bit of play. question i have is, are the 2 grooves in the stub for o-rings and if so where can you get them from? Also if i dont use them will silicone or similar do the job as theres quite a gap?

Ta
sef

[ArKaTxU]

Andy Francis have:
http://www.ekmpowershop12.com/ekmps/sho ... -336-p.asp
I want to know too if silicon or similar can do the job, because i have the same stub.
Now he have another stub:
http://www.ekmpowershop12.com/ekmps/sho ... 1610-p.asp

[bazman]

Think they done away with the stub that had the o rings as you had to replace them every time you took exhaust off.

[sydduckett]

What to do, what to do? Should really go for the stub but could just buy 4 rings as how often do i take the pipe off? Do you need 2 though, as there are 2 grooves? Also the one item on his site that doesnt have a buy button is yes you guessed it the stub...

Typical, will buzz him tomorrow.

[Bilko]

What size are these o-rings?

[sydduckett]

ended up buying the updated rb stub with a sleeve from Andy Francis.

Thanks for point me in the right directiom....

[Bilko]

I was going to buy a batch from ebay. Just need the size

[sydduckett]

I was going to buy a batch from ebay. Just need the size

Not sure best to call Andy Francis as he makes the franspeed and sells them. I think they need to be heat proof though?

[Bilko]

Ah ok. Thanks

[Bufficus]

These O rings were rubbish from the start and have not improved. I use acetoxy clear silicon sealant every time I remove my exhausts even on proper slip joints. Never had a problem.

You shouldn't have to pay £20 for a new stub due to a design fault.