Page 1 of 2
Jet 200 Dampers
Posted: Sat Sep 11, 2010 8:47 am
by Bones
Does anyone out there know if anyone is doing repro Jet 200 Dampers (9mm eye holes) OR does anyone know of any replacement dampers that fit?
I have tried Paoli dampers of an Italjet with custom spacers but they are way to hard and don't damp at all!
Any ideas would be welcome!
Re: Jet 200 Dampers
Posted: Sat Sep 11, 2010 9:27 am
by Fruitjuice
There's a type of Mini-front dampers that seem to fit perfectly, there was a picture of a Lammy Lynx/Lince with them fitted some time ago.
Re: Jet 200 Dampers
Posted: Sat Sep 11, 2010 1:05 pm
by mark
they may fit but they dampen both ways not one way
Re: Jet 200 Dampers
Posted: Mon Sep 13, 2010 1:17 pm
by shocky
im sure buzz solo moto does them as a remade item made in the EU as well
Re: Jet 200 Dampers
Posted: Mon Sep 13, 2010 4:50 pm
by soulsurfer
Re: Jet 200 Dampers
Posted: Mon Sep 13, 2010 5:50 pm
by mark
can you turn the damping off one way on these mike or just decrease it?
Re: Jet 200 Dampers
Posted: Mon Sep 13, 2010 5:57 pm
by soulsurfer
I really don't know Mark, I've not tried them, just read what it says in the description. Personally, I like the BGM dampers.
Re: Jet 200 Dampers
Posted: Mon Sep 13, 2010 8:14 pm
by Bones
BGM dampers
looking at these they appear to have standard 6mm eye ends which means they will not fit the 9mm Jet200 studs
Re: Jet 200 Dampers
Posted: Tue Sep 14, 2010 12:58 am
by shocky
Bones wrote:BGM dampers
looking at these they appear to have standard 6mm eye ends which means they will not fit the 9mm Jet200 studs
its only a push in insert they come out easily which is good and err bad
Re: Jet 200 Dampers
Posted: Tue Sep 14, 2010 11:39 pm
by panamesc
mark wrote:they may fit but they dampen both ways not one way
like any modern damper
i'm the one with the red and black spax
absolutely no problems , set them soft , ride like a ...... lambretta
it's even p'n'p
