Page 40 of 76

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Tue Jul 17, 2012 9:46 pm
by OAP
Image
My TT3

New SuperClubman (red) against the old Avanti Clubman (blue).
Still more to come.

Image

Dereks TT3

This graph shows the NK Road making (RED) 20.6 bhp @6238 rpm / 18ft/lbs @ 6147 rpm
Against the
New prototype Superclubman ( not the final one) 20.7 bhp @ 6983 rpm 16 ft/lbs @ 6619 rpm

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Tue Jul 17, 2012 10:03 pm
by Adam_Winstone
Wow!

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Tue Jul 17, 2012 10:11 pm
by OAP
To have a better comparison on the New clubman,
At the 1/8 mile sprint at Lincoln on Saturday Matthew Clarke had his TT3 there:
set up 60mm crank = 230cc
4.6:1 gear ratio
30mm Dellorto
Well known expansion box
Engine run in

Best run 65 mph

My TT3
225cc
4.6:1 gear ratio
30mm Dellorto
New Clubman
65 miles on the clock running rich

2nd run 63 mph

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Tue Jul 17, 2012 11:51 pm
by tarmac tickler
well bugger me!! didnt know you was there Ron,, i was the dummy in the coppers helmet with the speed gun on the finish line,, what a great day,, would love to do it again,,


i put a liner in a 225 rapido with a bridge like yours,, braized a brass heat sink to the iron to take the heat away from the bridge, MB remote reed 30mm pwk with power jet,stretch the air filter rubber over it and sat a sponge filter on top, early suzuki ts250 piston,outboard yamaha rod to accomodate the 18mm pin, li150 box standard sprokets goes like snot off a stick , looks a cracking kit your avanti,, well done

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Wed Jul 18, 2012 8:51 am
by OAP
That's the trouble coppers all look the same to me now, I was in disguise too, being an old fart.

Will have to meet up at a sprint somewhere.

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Wed Jul 18, 2012 1:19 pm
by Lambretta Sash
I managed between 64 and 65 mph at sprint, not bad for an engine built on Thursday, ridden to Lincoln Friday, sprinted 7 times on Saturday and thrashed home on Sunday :lol: :lol:

Hopefully when dyno'd should hit the 70 mph barrier on the next sprint watch out for the Lowestoft Lambretta Works Special :D

Any chance of posting results Tarmac Tickler ?

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Wed Jul 18, 2012 10:14 pm
by bubbles
.

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Wed Jul 18, 2012 10:56 pm
by tarmac tickler
Any chance of posting results Tarmac Tickler ?


not allowed to until they come out in scooterist mag,, otherwise mau will kick me in the bolloxs and eat all my bacon sandwiches again,, he,s the only bloke i know who goes camping without any equipment,, yet ends up the best fed!!!

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Sun Aug 12, 2012 3:18 pm
by sideout
Kit No. 123 installed and being run in :) :) :)

Re: Ron Moss - Avanti TT3 - Cylinder Kit - Review & Test....

Posted: Sun Aug 12, 2012 3:42 pm
by Andy Pickering
sideout wrote:Kit No. 123 installed and being run in :) :) :)
Good to hear mate..you will enjoy it, over 700 miles now for me :D