TS1 help

[red]

Looking at building a TS1 motor and was wondering what your views were on cranks and what type / size carb to use, any views welcome

my set up ts1 mb fast road tune 35mm tmk carb franspeed race pipe six plate clutch 58mm racecrank rb con rod fitted li 150 gearbox 47/17 sproket pulldown chain tensioner high load bearings fitted bgm stator,dont forget about you will need to uprate your suspension brakes tyres fuel tank...go for it :anbrgin;

And don't forget your bank account
:biggrin: :biggrin:

[GP Kevo]

Looking at building a TS1 motor and was wondering what your views were on cranks and what type / size carb to use, any views welcome

my set up ts1 mb fast road tune 35mm tmk carb franspeed race pipe six plate clutch 58mm racecrank rb con rod fitted li 150 gearbox 47/17 sproket pulldown chain tensioner high load bearings fitted bgm stator,dont forget about you will need to uprate your suspension brakes tyres fuel tank...go for it :anbrgin;

Does yours pull 4th strongly? I'm at 16 x 47 and feel like I could use another gear after 4th.

[warts]

Does yours pull 4th strongly? I'm at 16 x 47 and feel like I could use another gear after 4th.

Oh No!!

[stesjh]

Many thanks for all the advice / opinions there seem to be so many - time for much thought I think

[lockman69]

What have you got now?
And, what do you want a TS1 to do that your existing one doesn't?

Just a box standard SIL 200, pretty slow and seized a few times now would like something with a little more uummpphh and TS1's have been around for a long time and seem pretty tried and tested

I am currently running a cleaned up stage 4 , 30mm delly and JL3....it will sit at 65-70 (gps and fat git) all day long, tank to tank, slightly over jetted main jet using a egt the temps remain constant at wot....my TS1 nolonger gets a look in!

Next project, could be to rip off edens engine spec.....but dont tell him :baddevil: :bigsm:


Lockman 69 (Iron barrel believer)

[nelson pk]

slightly over jetted main jet using a egt the temps remain constant at wot

Thats easy to do. Getting it nice and cool at 1/4 to 1/2 throttle at higher revs is the hard bit

(Iron barrel believer)

That makes two of you then

Nelson PK (good quality ally barrel believer)

[lockman69]

slightly over jetted main jet using a egt the temps remain constant at wot

Thats easy to do. Getting it nice and cool at 1/4 to 1/2 throttle at higher revs is the hard bit

(Iron barrel believer)

That makes two of you then

Nelson PK (good quality ally barrel believer)

1/4 to 1/2 throttle....Whats that???

[nelson pk]

Good answer