Scooterotica

Posted: **Tue Mar 08, 2011 11:43 pm**

There's a place in Middlesbrough which is where I am, a lad has his done there and wait for it the uses water!!!! At like super high pressure cost him a tenner not a mark on it and was ready the next day!

Posted: **Sat Mar 12, 2011 11:30 am**

Waterjet cutters operate at 60,000 PSI and cost a lot , so a tenner is quite reasonable for a superneat job if you are not to handy with a hole cutting bit

Scooterotica

Cutting a hole in my side panel for carb ?????

Re: Cutting a hole in my side panel for carb ?????

Re: Cutting a hole in my side panel for carb ?????