Lambretta Keys to the ignition

[kejj]

I have an original ignition and one key only, works but is slightly bent.
I remember people talking about some guy in UK that could make copies of the keys with the lambretta key number (or lock number).

Anyone remember who it was and how to get in contact?

[timexit17]

Jem Booths the man I believe?

[Mr Ed]

This is an e-mail address I used to contact him some years back.He is a hard man to track down, really busy so persevere. Hope this email still works. Took me over a month to contact him, but when I did the job was done immediately. [email protected]

Some phone numbers here but I could never get an answer. Scroll to end of page: http://www.lunabase.co.uk/parts_jem.php#contact

[RICSPEED]

he looks in here quite regular

http://scooterotica.org/forum/memberlis ... ile&u=1165

if you want to pm him

[kejj]

Thanks! Will PM him and see if I get a response!
I have only got one key and I hope the ignition still works. Haven't tested it since the scooter was not in a runnable state when I got it.

The rusty key:
http://tv175.files.wordpress.com/2011/0 ... .jpg?w=450

[peterh3197]

I recently needed a spare key for my Lynx. Went to proper locksmith who identified the blank no. They couldn't supply the blank as they didn't have one in stock and would need to order 10. I got in touch with N W Keys, http://www.nwkeys.co.uk/Portal.aspx?page=27, who supplied me with a single blank and I got it cut. N W do want you to send your key up to get it cut, but if you ask nicely, 'cos you don't want to lose your key in the post, they will send the blank. Total cost including cutting £6.22.

[kejj]

Haven't heard anything yet so I will try the mail.

Good idea there, will try a local locksmith again and ask them.