Rear peg images

[sydduckett]

The guys that are doing the welding are pretty good but noted, the idea was to let them in where the pegs touched the panels when folded up. Im doing this from memory as i have the panels here but the scoots elswhere. the rubber buffers are further up the strutts and the panels dont touch the outriggers where they will be let in so should be able to let in a few mill without ruining the ridgity..right word?

sef

[joey]

...whats wrong with foot boards????....

[sydduckett]

...whats wrong with foot boards????....

There for gayers.... nah my floorboards have been shortened & welded so dont have much choice. Cmon where are these pics....

[Markus]

have you actually ridden far with your feet back there ? I found it too far back for me, so went this way :

using kawasaki pegs, some bits of GSXR hangers, homemade brackets and Scooter Loopy John exhaust clamps on engine mounts.

Nice solution!

Do the plates on the left peg just rest on the mag housing to stop the peg from twisting?

[lee b]

clamps on the engine mounts,think its further in on this thread.good solution!!

found a place to order the uj b.t.w!!

[sydduckett]

Wheres my fecking pics....

[RICSPEED]

now now

this is the best i can do in my pics

[sydduckett]

now now

this is the best i can do in my pics

Nice scoot, like the way the panels are cut, how about a close up....

[RICSPEED]

[sydduckett]

Wan**r, go to bed!