Casa 185 kit

[minotaur]

you should avoid 2 up for a bit, i use a sito ancillotti exhaust and seems good to me

[TS1-200]

An ordinary AF Clubman works well. no need to spend more money on expansions or the "improved" clubmans

[Funkspeed]

As a matter of interest what carbs/jets are folk running on these? I'm not sure about the jetting in mine but at the moment running a 20mm Delorto running through the airbox.

Even though kit only recently fitted it does seem a bit "strangled".

[minotaur]

i run a 24mm PWK through a ram air filter, and a lightened flywheel

[Stokie]

Has anyone done a port map of this kit that they can post or know the port timings ?

[L4Lambretta]

Hope you don't mind me hijacking this forum; Minotaur, what jetting are you using. Have the same carb and casa kit, and finally some time to put it all together. Think I'll use a Gp air box.

[minotaur]

i'll take off carb tomorrow and check as i'm fitting a powerjet anyway, and will then need to re-jet, i will let you know

[Funkspeed]

Now found out that motor has already been run in.

Think I'll be changing from the standard carb 22 mm through airbox to a 24mm or 26mm.

I'll be looking at a decent exhaust too.

Any recommendations at all to get the best out of this kit as seems quite sluggish at the moment?

[minotaur]

i've, just fitted an oko pwk with built in power jet i found on ebay germany, 36 pilot , needle 2nd clip 112 main, ram air remote and sito ancilloti exhaust , gp 200 gearing, the pwk with powerjet is a differnt proposition to the normal one, lovely to ride, smooth even power from t. over to w.o.t, not a blip thru the range