hello there just wanted to know if any body can help me. i striped the clutch any variator out of my dragster about a year ago and put all the bits safely on the side then my misus decided to knock everything over. now its been a while and was just checking if there should be a washer between the variator and the water pump pulley on the crank as i cant find any good diagrams about
any help would be much appriciated
cheers Dan
dragster engine
-
vesbrettas
- registered user
- Posts: 55
- Joined: Tue Jun 09, 2009 2:33 pm
- Contact:
[quote="vesbrettas"]was just checking if there should be a washer between the variator and the water pump pulley on the crank as i cant find any good diagrams about
no dont think so hope this helps
no dont think so hope this helps
Best asking on http://www.scooter-scene.co.uk quite a few into dragsters and I'm sure some one could answer this for you
Just click the fourum tab
Just click the fourum tab
Its in bits scooter club: www.facebook.com/groups/132415046859320
-
C*NTSPEED
- registered user
- Posts: 395
- Joined: Wed Jan 07, 2009 11:44 am
- Main scooter: vespa ts 125/200
- Location: manchesto's beruit
- Contact:
is it a standerd variator if so then no but if polini or malossi they both have a 4mm washer that fits on the crank before the variator backplatevesbrettas wrote:hello there just wanted to know if any body can help me. i striped the clutch any variator out of my dragster about a year ago and put all the bits safely on the side then my misus decided to knock everything over. now its been a while and was just checking if there should be a washer between the variator and the water pump pulley on the crank as i cant find any good diagrams about
any help would be much appriciated
cheers Dan
then...
the gap is the flypully half
GEMINI S.C.
BLACK WIDDA'S S.C.
BLACK WIDDA'S S.C.