sleeving

[C*NTSPEED]

ok who does the steel liners prefer them not to pull thi pants down on the price if possible?

[shocky]

quality cost and you wont beat these guys for service ,quality and detail not had a cylinder relighned but had rebores and a car block honed by them they put alot of scooter dealers to shame with there knowledge proper british enginners http://www.pjme.co.uk/

[Mick Abbey]

quality cost and you wont beat these guys for service ,quality and detail not had a cylinder relighned but had rebores and a car block honed by them they put alot of scooter dealers to shame with there knowledge proper british enginners http://www.pjme.co.uk/

I use PJme for my crank rebuilds and there work is top quality I have also used them for a couple of re sleevs and the finish was second to none I am not so sure if they do any pistons or sleves for lamys you will have to give them a call on 01902 307457

Cheers
Mick

[shocky]

they have done several TS1 kits and some out to 71mm using the weisco piston

[sideswipe]

Try Fahron engineering in Hucknall, Notts. They've done a couple for me, good price and good quality. I'll dig out their number tomorow at work.

[Dazza]

I contacted pjme recently, to reline a rapido will cost £120 but you have to supply a piston of choice.

I would like to see the details of the hucknall chaps, only down the road from me .

[C*NTSPEED]

ooooo just been given a ts1 200 barrel decisions decisions whats thi to do????????????????????

[sideswipe]

Fahron Engineering
Wighay Road
Hucknall
Notts NG15 8AH

Tel. 01159 634 123.

No website I'm afraid, he doesn't advertise.

I know he used to do a lot of barrels and cranks for SES, he knows 2 strokes aswell.

[C*NTSPEED]

Fahron Engineering
Wighay Road
Hucknall
Notts NG15 8AH

Tel. 01159 634 123.

No website I'm afraid, he doesn't advertise.

I know he used to do a lot of barrels and cranks for SES, he knows 2 strokes aswell.

cheers pal had a chat wi him today and i will be using his services just need to find a good piston kit

[shocky]

Fahron Engineering
Wighay Road
Hucknall
Notts NG15 8AH

Tel. 01159 634 123.

No website I'm afraid, he doesn't advertise.

I know he used to do a lot of barrels and cranks for SES, he knows 2 strokes aswell.

cheers pal had a chat wi him today and i will be using his services just need to find a good piston kit

so how much does he charge for this compaired to pjme