Plug chop colours

[Norrie Bodge]

Might make that weekend m8

[alanscottj]

Might make that weekend m8

Got around to using one of your washers under the clip. Had a nice spin around town and she runs great, a tiny bit of splutter every now and then as I just go over 1/2-3/4 throttle. A clip down she was un-rideable but with the washer spot on. Not done a proper chop yet but as I got home pulled clutch in and cut her off as I approached my house and checked plug - much darker than before. Not sure about the lightness of the tip but I'm sure someone on here will enlighten me. Will do some proper chops later but it looks promising. I'm sure she is safe until dyno anyway.




Sent from my iPhone using Tapatalk

[Scooterdude]

Hate to say it as I think I told you to use a colder plug..... but now looks like you need a hotter one!

Or you could try leaning it off half a turn on the mixture screw and see how it goes.

[alanscottj]

Hate to say it as I think I told you to use a colder plug..... but now looks like you need a hotter one!

Or you could try leaning it off half a turn on the mixture screw and see how it goes.

BR8ES at different positions after a good run.














Sent from my iPhone using Tapatalk

[Scooterdude]

Picture 2 and 4 work for me. Heat range of plug fine, just put it back in and enjoy it.

[alanscottj]

Picture 2 and 4 work for me. Heat range of plug fine, just put it back in and enjoy it.

Last picture was full throttle so might just up my main (currently 320) and leave it alone until dyno. I'm only thrashing around the lanes so never hold it open for long periods any way. It's nice to ride and fast. Thanks for your input bud