gt200 ?
-
- registered user
- Posts: 231
- Joined: Sat May 09, 2009 2:31 pm
- Contact:
Can anyone tell me what timinig people are using on there gt200 kits, I'm using a bgm box pipe ., steve
-
- registered user
- Posts: 231
- Joined: Sat May 09, 2009 2:31 pm
- Contact:
Thanks for the reply Rich, thats what im curently running , the reason for the question is i had i slight seeze , and checked the plug and it was grey rather than a nice brown colour , my other settings are 30mm phbh 130 main , x13 on 2nd clip , 40 float, 55 pilot , any ideas? Steve
which atomiser?
main is a little small... use 135
main is a little small... use 135
- drunkmunkey6969
- Moderator
- Posts: 2838
- Joined: Sun Jan 04, 2009 1:42 pm
- Main scooter: '69 Lambretta GP
- Location: North Yorkshire
- Contact:
Hey Rich, I'm quite surprised at the suggested 18/19 degrees on the box pipe.Rich_T wrote:With box pipes 18-19 degrees. With expansions 17-18 depending on rev range.
Out of curiosity Rich, what's your personal reasoning on the differential between ignition timing on box pipes vs expansions? I'd be intrigued to know. Cheers, Dan.

See our YouTube scooter channel for Tech-help: https://www.youtube.com/c/TheScooterFactory/videos
-
- registered user
- Posts: 231
- Joined: Sat May 09, 2009 2:31 pm
- Contact:
hi Eden the atomiser is an av268, Steve
-
- registered user
- Posts: 231
- Joined: Sat May 09, 2009 2:31 pm
- Contact:
Rich , the engine spec is as follows
60/110 gt crank , bgm box pipe , 30mm phbh with breathsweet ,x13 needle 2nd clip from top, av268, 55 pilot , 130 main
engine has done about 150 miles so far with no problems just started to take it to about 50mph over the last few days and as i say it nipped up on me , plug colour is light grey , any help would be great
regards , Steve
60/110 gt crank , bgm box pipe , 30mm phbh with breathsweet ,x13 needle 2nd clip from top, av268, 55 pilot , 130 main
engine has done about 150 miles so far with no problems just started to take it to about 50mph over the last few days and as i say it nipped up on me , plug colour is light grey , any help would be great
regards , Steve
- Rich_T
- Dealer
- Posts: 540
- Joined: Fri May 29, 2009 8:07 pm
- Main scooter: Li Special
- Location: Birmingham
- Contact:
The main is a bit weak but even so if you are still running it the plug should not be grey by any stretch. Does the engine tick-over nice and start first or second kick from hot and cold? Are you using a porcupine head and a copper head gasket, base packer and gaskets? How many of the packers and gaskets are GT parts. How old is the carb. When you had a nip up, what were you doing (apart from riding), accelerating, decelerating, what speed? How are you "running in" around town, long runs, are you giving it full throttle? What plug are you running?