hi has any one done the fuel bowl mod
want to know if you drill the 2mm hole at a angle or side ways and how deep
any info much appreciated
dellorto si 24/24 mod
1.7 mm streight
live life your a long time dead
It goes into a chamber behind so don't push too hard
live life your a long time dead
-
gaz_powell
- registered user
- Posts: 1208
- Joined: Sat Mar 28, 2009 1:10 pm
- Location: hartlepool
- Contact:
Follow the existing hole.
According to SIP you can open it up to 2.0mm on the P2 but from memory I only had a 1.8mm bit so used that just to open it up abit.
Are you putting the float bowl on with the 5.2mm valve?
According to SIP you can open it up to 2.0mm on the P2 but from memory I only had a 1.8mm bit so used that just to open it up abit.
Are you putting the float bowl on with the 5.2mm valve?
-
gaz_powell
- registered user
- Posts: 1208
- Joined: Sat Mar 28, 2009 1:10 pm
- Location: hartlepool
- Contact:
-
smiffy1968
- registered user
- Posts: 100
- Joined: Thu Mar 31, 2011 11:58 am
- Main scooter: Nevermind Mk1 T5
- Location: Ipswich
- Contact:
2mm hole all the way to bottom of main jet stack. Cosa bowl cover 5.2mm needle. Drill down to needle seat. I did 2.5mm all the way. Opened up fuel inlet too. 3mm bowl cover packer. Job done no fuel starvation issues anymore.
Sent from my SM-G903F using Tapatalk
Sent from my SM-G903F using Tapatalk
Or get the new pinassco 30mm carb
-
rosscla
- registered user
- Posts: 4823
- Joined: Tue Oct 25, 2011 9:50 pm
- Main scooter: Lambretta
- Location: Lanarkshire
- Contact:
Is it released yet?hungdog wrote:Or get the new pinassco 30mm carb
"Our dilemma is that we hate change and love it at the same time; what we really want is for things to remain the same but get better."
-
Muttley McLadd
- registered user
- Posts: 1496
- Joined: Wed Jan 07, 2009 6:32 pm
- Contact:
Aiming for last June, according to sites found by Google.rosscla wrote:Is it released yet?hungdog wrote:Or get the new pinassco 30mm carb
CakeAndArseParty