Plastic drip tray.

[10 inch Terror]

Hi all, I'm after the best way to fit a new splash / drip tray on a standard petrol tank. Any hints / tips very much appreciated. Thank you in advance Pete.

[bristolmod]

stick it in very hot water then place on neck of tank, AFTER putting felt ring on.

[challenger]

Warm it up and push it in from the Top of the frame loop. Its a bit tight but it will bend and spring back into shape after you get it through the hole,

[10 inch Terror]

Cheers fellas. Hot water it is then.

[HxPaul]

Once mine is fitted I then put the felt ring on top,that way it stops dribbles of fuel and can be taken out and dried (I just squeeze mine dry and re-fit).Some drip trays are made of hard plastic and no matter how hot the water is,it wont soften.I got one of these off Ebay and had to replace it.

[hendy]

Can't remember where I got mine but it's made by atomic. It's white plastic and like hxpaul says there's no way to get it on with hot water. I hacked so much plastic out of it that I reckon I've halved it's weight!

[10 inch Terror]

It's a Scootopia one, so hopefully will fit ok.....

[garry inglis]

must be close to finished if your fitting drip trays 10 inch

[Scooterdude]

Yes I bought one from Scootopia, just couldn't get it to go in at all...... Until it came time to fit the floor rubbers in the alloy channels which I had to boil before I could get um in, anyway that prompted me to boil the drip tray which then went in no problem.

[10 inch Terror]

must be close to finished if your fitting drip trays 10 inch

Just the legshields and rear runners to paint now. I'll post some more pics soon.