TS1 Reed Valve Screws - Size

[paulnobodyimportant]

My phillips head screws look like they have been loctited fully in and all I'm doing is rounding off the heads. I've a spare cage but no screws. Does anyone know the size so that in can order some. From looking at other forums, hex heads are recommended.

[wack 63]

M3 x 0.5

[paulnobodyimportant]

Thanks Wack 63. And in a separate eureka moment I came across these loose screws from a PC that I stripped. They are M3 and some are of the correct length, but they are stainless steel, rather than brass, but don't think that will be an issue.

[wack 63]

Just make sure to put a dab of Loctite on them, then just gently nip up. Also check the heads allow the block to fully seat flat in the cylinder.

[corrado]

I came across these loose screws from a PC that I stripped.

It's not just me that does that then.