lambretta turntable.

[diesel]

231 kg Griso - I can't even lift the rear end on my own.

Some form of dolly might be useful. Would anyone know where to get such a device?

[Timbo]

I have one of these for my Harley, allows me to push it close to the single garage wall. A smaller version that would support a Lambretta stand is what I'm after...

http://www.ebay.co.uk/itm/500lb--Motorb ... SwCypWo0EU

[wrecklessrobbie]

A zr7s......is a midlife crisis purchase

Robbie

[mickfeath.]

That's what i'm after Timbo, just something in can stand my lambretta on and turn it round in my garage, without having to wrestle it round.

[EddieStone]

That's not too hard to make, is it? Some decking or similar, and some chair castors: http://www.wilko.com/all-hardware/wilko ... vt/0344941

[DigDug]

That's not too hard to make, is it? Some decking or similar, and some chair castors: http://www.wilko.com/all-hardware/wilko ... vt/0344941

The issue would be getting the scooter on it without having to lift it by hand.

[mickfeath.]

I've sorted it. Thanks for all your replies, Mick.

[DigDug]

I've sorted it. Thanks for all your replies, Mick.

Be interesting to see the solution.

[mickfeath.]

Hi, just a couple of pieces of timber , 6 locking castors' ,put it under the scooter, place the scooter on its stand and the front wheel comes off the ground, you then just lift the back end slightly, and the scooter can be turned round to face the other way.

[DigDug]