This one seems to be made of much thicker metal and a normal 'jubilee' clip,like I always used in the past,doesnt close the stub enough to stop the fumes blowing past it.
Standard series 2 exhaust
Anybody know where I can get a strong clamp for the tailpipe on a standard series 2 exhaust?
This one seems to be made of much thicker metal and a normal 'jubilee' clip,like I always used in the past,doesnt close the stub enough to stop the fumes blowing past it.
This one seems to be made of much thicker metal and a normal 'jubilee' clip,like I always used in the past,doesnt close the stub enough to stop the fumes blowing past it.
-
Nerdy Norm
- registered user
- Posts: 238
- Joined: Tue Dec 18, 2012 6:47 pm
- Main scooter: Lambretta LI 150 S3
- Location: Belgium
- Contact:
Lambretta LI125 Series 2, Lambretta LI150 Series 3, Lambretta J100 Cento, LML Star 150 2T
Thanks for the reply,but its the tailpipe clamp that I'm after,the link was for a downpipe/silencer clamp.
I'm pretty sure that this particular exhaust is of Spanish origin,and is made of much thicker metal than the Italian pipes that I'm used to.
I need something like a small 'U' clamp to make a tight seal.
I'm pretty sure that this particular exhaust is of Spanish origin,and is made of much thicker metal than the Italian pipes that I'm used to.
I need something like a small 'U' clamp to make a tight seal.
I need a 24mm clamp,the smallest i can find is 28mm
-
HxPaul
- registered user
- Posts: 1110
- Joined: Fri Dec 06, 2013 1:58 pm
- Main scooter: lambretta Li 150
- Location: Halifax,Yorkshire
- Contact:
These clamps go as small as 17-19mm.
http://www.ebay.co.uk/itm/MIKALOR-W2-St ... QHRzZweS4g
http://www.ebay.co.uk/itm/MIKALOR-W2-St ... QHRzZweS4g
Im going to try one of those,but the metal is that thicki reckon it will need a 'u' clamp to make proper seal.