Do you mean the scooter or scamadi forks ? the scooter uses an outboard shock with a 12mm fixing pin top and bottom like this but these are of my own makingMuppet wrote:does the scomadi use stock type dampers?
NOS TS1
We sleep soundly in our beds because rough men stand ready in the night to visit violence on those who would do us harm
have managed to get a little done, but not as much as i would like,
Cylinder shroud was done, then i discovered fan was to far away from the fan cover, so Ive modified that to close up the gap and will be getting the shroud modified to suit.
stripped and detailed my PWK, plus modified it to fit my nitrous injector
Forks were stripped again and new stainless brackets welded in the right place this time
Also added the anti dive bracket as well.
Discovered a small crack in one of the lower fork half's obviously from when they were formed, so that was fixed also.
Forks are just about ready to put back together now after Ive finished remetal finishing them.
Cylinder shroud was done, then i discovered fan was to far away from the fan cover, so Ive modified that to close up the gap and will be getting the shroud modified to suit.
stripped and detailed my PWK, plus modified it to fit my nitrous injector
Forks were stripped again and new stainless brackets welded in the right place this time
Also added the anti dive bracket as well.
Discovered a small crack in one of the lower fork half's obviously from when they were formed, so that was fixed also.
Forks are just about ready to put back together now after Ive finished remetal finishing them.