Just fitting an original Ancillotti seat to my Rally 200, it fits round the raised tank ok, but the fuel cap fastener is tight against the seat base, and I wondered if anyone has used / knows of a flatter fitting fuel cap I could use, or will I have to reprofile the seat base with the standard servcieman's tool (lump hammer)?
Thanks
Vespa Rally fuel cap
-
scooterspy
- registered user
- Posts: 8
- Joined: Sat Jan 09, 2010 9:04 am
- Contact:
-
fraggleexport
- registered user
- Posts: 37
- Joined: Wed May 02, 2012 11:13 pm
- Main scooter: vespa sprint
- Contact:
I think there are only two styles that fit the Rally 'raised' tank style. An original Rally seat and....oh hang. I think there is only one style that fit the Rally 'raised' tank style 
Its a bummer for sure because basically any Rally you see without the original fat seat has either got a replacement tank or the seats been altered underneath.
Kevin
Its a bummer for sure because basically any Rally you see without the original fat seat has either got a replacement tank or the seats been altered underneath.
Kevin
-
scooterspy
- registered user
- Posts: 8
- Joined: Sat Jan 09, 2010 9:04 am
- Contact:
Cheers Kevin, lump hammer it is then!
Mike
Mike