One-off laser steel cutting

[Sam_C]

Hi all.

I have a piece of 2mm mild sheet steel which I want to cut a one-off design into. Nothing fancy, its just words in "joined-up" writing! I'm thinking laser/CNC? Anybody had anything similar done, is it generally a sensible price, and....anybody know anyone in Yorkshire (preferably North Yorkshire) who does this sort of thing? The other option is paint the steel and put the words on (rather than cutting through the steel) again with paint using a cut-out mask. But...cutting out is the favourite, so any help much appreciated

Rgds Sam

[corrado]

PM sent.

[vicvega]

If you find someone can you post it up, I was after getting a set of foot plates done but can't recall who does/did them. Cheers

[wack 63]

What about clutch steels?

[joespeed]

,malton laser,doncaster laser,campbells of hull are a few i use

[Cereal GY]

Chiggy Chambers at Lambretta Upgrades is a very good option.