What mpg should I be getting from my 220 malossi,set up is 30 delly carb,210 malossi kit (old type) rd type reed valve,60mm bell crank,casings matched to cylinder and rz right hand pipe,its doing about 30mpg and I got a standard tank so loads of stops when doing a run,any way of increasing fuel economy without losing to much power.
cheers Jeff
fuel consumption malossi 220
I used to get about between 60-70 miles per tank with a similar set up. Couldn't really go anywhere without a petrol can on the back.
- Muttley McLadd
- registered user
- Posts: 1496
- Joined: Wed Jan 07, 2009 6:32 pm
- Contact:
Ride slower..?1469leach wrote:any way of increasing fuel economy without losing to much power.
CakeAndArseParty
- Muttley McLadd
- registered user
- Posts: 1496
- Joined: Wed Jan 07, 2009 6:32 pm
- Contact:
What answer did you expect?
I'll expand then..
When you're riding, are you always caning it? Is every ride a race?
Is your gearing super low, causing you to be doing 7/8/9k revs everywhere?
When you're tipping along at a steady rate, is your throttle all the way open, or have you had it set up so that it runs nicely with a 1/4 throttle?
When you go up hills, do you accept you're going to be going a bit slower, or do you open it up to speed up a bit?
Do you really need such a big carb on it?
I'll expand then..
When you're riding, are you always caning it? Is every ride a race?
Is your gearing super low, causing you to be doing 7/8/9k revs everywhere?
When you're tipping along at a steady rate, is your throttle all the way open, or have you had it set up so that it runs nicely with a 1/4 throttle?
When you go up hills, do you accept you're going to be going a bit slower, or do you open it up to speed up a bit?
Do you really need such a big carb on it?
CakeAndArseParty
-
- registered user
- Posts: 31
- Joined: Mon Sep 07, 2009 11:10 pm
- Contact:
On mine, I always thought at 50 miles, start looking for a petrol station to be safe........... seems par for the course....
-
- registered user
- Posts: 214
- Joined: Mon Jul 29, 2013 8:18 am
- Main scooter: PX221
- Location: London
- Contact:
As said already, if you are not thrashing it everywhere then something is certainly not right. Assuming everything is generally ok with your engine and you are riding it normally then it is either leaking or jetting. If the float bowl level is too high some carbs leak petrol out of the carb breather holes when you rev it. Most likely though is your pilot jet is too big or your atomiser is too big. Making either of these smaller will not affect top speed any 

Vespa est ieiunas, quia semper operaturi
-
- registered user
- Posts: 214
- Joined: Mon Jul 29, 2013 8:18 am
- Main scooter: PX221
- Location: London
- Contact:
So, what jets/atomiser you got fitted right now? 
The atomiser number is the size. As small as possible (often rnds up as 264 on a Malossi). You feel the atomiser size when the throttle is open an 1/8th

The atomiser number is the size. As small as possible (often rnds up as 264 on a Malossi). You feel the atomiser size when the throttle is open an 1/8th
Last edited by Jack221 on Tue Mar 25, 2014 7:47 pm, edited 3 times in total.
Vespa est ieiunas, quia semper operaturi