Ahh, those wires.... Help please

[Fux]

Iv`e been messing about with my series 2 (li150) for over a year now and tonight I finally got it running.

I have, however no lights and on a loom that worked fine before the re-build.

I have fit a Jockey`s headlight conversion, so I had to take out the headset wire junction thingy.

Up front I have a casa li s.2 switch and the original kill switch (no ignition key)

Which wires should be connected to what?

[byron]

is this on the loom I built for you ?
if so, I'll have a diagram somewhere

[Fux]

Hi buddy, The TV worked a treat and I still have the diagram you made for me and it still works, just under a different rider ( ie. sold the bugger)

The one I have now is simplified loom, 12v. Just not simple enough for me how to figure out how to wire up the li switch...

[byron]

good to hear the TV is still running well
I'm not familiar with the jockey headlamp conversion, got a diagram ?

[Fux]

Its just a Halogen headlight, it sits a little to deep in the headset to be able to use the original conector thingy. Three wires.

http://www.jockeys-boxenstop.de/shop/en ... ?q=halogen

I wont use the pilot light because daytime headlight is compulsery in scandie.

[byron]

can't tell much from those pictures
you need to get the rubber cover off, and see where the wires go...
is it bayonet bulb, or H4 type ?

[Fux]

Its a H4.